Well pump replacement in Cartersville
Most well pumps in Bartow County sit down in the well, out of sight, until the day the water stops. When a pump has truly worn out, replacing it is the fix that gets your house back to normal. Here is what that job looks like, what drives the price, and how to tell whether you need a new pump or just a repair.
Call (678) 535-2432When a pump needs replacing, not repairing
A pump that runs but moves little water, trips the breaker every time it starts, or hums without pumping is often at the end of its life. Submersible pumps in this part of Georgia commonly last somewhere between 8 and 15 years, depending on how hard they work, how much sediment is in the water, and how often they cycle on and off.
Before anyone pulls a pump, a good well pro checks the cheaper suspects first: the pressure switch, the breaker, the control box on a three-wire pump, and the wiring at the well head. Plenty of "dead pump" calls turn out to be a twenty-dollar part. If those check out and the motor reads open or shorted, replacement is usually the right call.
What the job involves
Replacing a submersible pump means pulling the whole drop pipe out of the well, sometimes a few hundred feet of it, along with the wire and the old pump. Deeper wells take more time and often a pump truck with a hoist. The crew then sets the new pump, splices and seals the wire, adds a check valve where it is needed, and lowers everything back down.
Once the pump is back in, they bring the system up to pressure, check the amperage the motor draws, and confirm the pressure switch turns the pump on and off where it should. Many homes are back on water the same day.
If the pressure tank is old or waterlogged, it is worth replacing at the same time. A failed tank makes a new pump short-cycle, which wears it out early.
What it often costs around Bartow County
A full pump replacement is often in the $1,500 to $3,500 range. The biggest factors are how deep the pump sits, what horsepower the house needs, whether new pipe and wire are needed, and whether a pressure tank goes in too. Shallow jet pumps at the house are usually on the lower end; deep submersibles with new drop pipe are on the higher end.
Ask for the price of the pump, the labor, and any pipe, wire or tank as separate lines, so you can compare quotes fairly.
Getting it done
Call or send the form and a local well pump pro serving Cartersville, Adairsville, Kingston, White, Emerson, Euharlee and the rest of Bartow County will call you back. It helps to know roughly how deep your well is, how old the pump is, and what it was doing before it quit.
Common questions
How long does a well pump replacement take?
Many are done in a few hours once the crew is on site. Very deep wells, stuck pipe or a pump that has to be fished out can take longer.
Can I keep using water while I wait?
If the pump has stopped, no water will come from the well. Keep bottled water on hand for drinking and cooking, and fill a few buckets for flushing if a neighbor or a hose bib elsewhere can help.
Should I replace the pressure tank too?
If the tank is more than ten or so years old, has rusted, or the pump has been clicking on and off rapidly, replacing it alongside the pump is often worth it.
Related:No water from your well · Well pressure tank problems and replacement
Rather not call? Send the details
A local well pump pro will call you back.